Fixed some minor semantics

2026-09-09 23:02:54 +02:00
parent 6352f9b7b2
commit 70c9c30bbc
2 changed files with 3 additions and 3 deletions
@@ -27,11 +27,11 @@ The design was printed (unfortunately not mirrored ;) on two sheets of foil (usi

 There are some visible breaks in certain places, such as next to the label `2.0mm`. However, this is due to the printout. The same reason explains why the conductor paths merge at the thinnest point.

-The circuit board was then etched in 300 g of sodium hydroxide solution (etchant: NaOH) at a ratio of 1:100. The etching time was a little over 10 minutes.
+The circuit board was then etched in 300g of sodium hydroxide solution (etchant: NaOH) at a ratio of 1:100. The etching time was a little over 10 minutes.


 ## Conclusion

 So: the exposure time is 19-20 minutes, which is as expected - the time has been cut in half, from 42 minutes to a nice round 20 minutes!

-In any case, for the next project (which will be the subject of an upcoming article), the imagesetter produced results with this setting that were truly satisfying—at least for me.
+In any case, for the next project (which will be the subject of an upcoming article), the exposure unit produced results with this setting that were - at least for me - truly satisfying.